Pictures & frames

Make a full-size picture mounting template.

Measure the frame once, enter where the hanger or D-rings sit on the back, and print a paper guide you can tape to the wall before placing a nail, hook, or anchor.

What you’ll enter

1The frame’s outside width and height.
2Each hanger’s distance from the nearest side edge.
3Each hanger’s distance from the top or bottom edge.

Why use a paper mounting template?

Transferring measurements from the back of a frame to a wall is simple in theory and surprisingly easy to get wrong in practice. A full-size template keeps the frame outline and hanger locations in the same coordinate system.

Two D-rings — no wire

Use this guided setup when each D-ring hangs directly on its own wall hook. Measure each ring from its nearest side and from the top of the frame.

One centered hanger or sawtooth

Use the centered-hanger option only when the hanger is actually centered left-to-right.

Hanging wire

The guided wire option is for one centered wall hook. Pull the wire upward at the center as it will sit on that hook and measure to the peak. For two wall hooks or an off-center setup, use the custom template.

Before hanging

Verify the calibration mark on the printed page, confirm the hardware is suitable for the frame and wall, then tape the template in position and transfer the mark.

Ready to mark it on the wall?

Use your actual measurements and print the template at full size.

Create template