Towel bars & wall hardware
Position both mounting plates with one printable guide.
Towel bars, toilet-paper holders, and wall accessories often use two separate plates. Put both plate locations on one full-size paper template.
What you’ll enter
1For the guided two-plate setup, the distance between mounting-plate centers.
2The vertical center-to-center spacing between the two holes on each matching plate.
3If your plates use slots, horizontal holes, or another pattern, use the custom template.
Keep two mounting plates aligned.
The challenge with a towel bar or similar accessory is not only the screw spacing inside each plate—it is keeping both plates level and at the correct distance from each other.
Measure the actual hardware
The guided towel-bar and holder options are only for matching plates with two vertically aligned holes. If your hardware differs, switch to Other and copy the actual fastener locations from the hardware or manufacturer instructions.
Position the whole assembly at once
Tape the printed guide at the intended height, level the paper, verify clearances, then transfer the marks.
Ready to mark it on the wall?
Use your actual measurements and print the template at full size.